Before you start using your Generac portable generator, it’s important to remember some important steps. If you use a pull card to start the generator, make sure it’s disconnected from the electric cord first. The pull card may not rotate properly due to pressure buildup. Make sure that the battery is fully charged and connected to the generator, or disconnect it. Then, follow the rest of the steps below.
Using a 50-Amp outlet
It may seem odd that a portable generator with a 50-Amp outlet would be noisy, but it can be a great option for RVs. It is easy to start and run and can handle power needs of up to 8500 watts. But, it is not silent, so you need to consider your needs before buying one. The first thing to consider is whether or not you need a generator with a 50-Amp outlet. If your generator needs to be silent, you may be able to use the generator’s 30A outlet, but it is better to look for a unit with a 50-Amp outlet.
In addition to the standard 30-Amp receptacle, a Generac portable generator can also be powered by a 50-Amp power inlet box. This cord is made of a special type of rubber that allows it to be flexible in cold weather. This cord is also compatible with Generac portable generators up to 7500 Watts and 50-Amp outlets.
Using a recoil cord
If you are having trouble starting your generac portable generator, you might need to use the emergency recoil option. To do so, simply use the recoil cord to start the engine. The recoil assembly on your generator consists of a silver cup which receives the pawls that pull the recoil cord. To start the engine, pull the rope until you feel resistance and then release it. Pull the rope clockwise around the cup, not to tighten it. Be sure to let the rope fall off the cup at the end of the pull.
The recoil cord is attached to a pulley located on the side of the generator. Pulling the cord will open the recoil spring, which then winds the engine’s piston. A broken pulley will not maintain the tension of the recoil spring, which makes it difficult to pull the cord. A cracked or broken pulley may result in the cord becoming stuck.
Using a through-the-wall kit
Using a through-the-wall starter kit for your Generac portable generator is a great way to begin powering up the generator. Generac has an extensive library of kits available for various portable generators. You’ll also find helpful wattage reference charts. You can also read about starting the generator to avoid any surprises. Using a starter kit for a Generac portable generator can be a hassle, but the benefits far outweigh the inconvenience.
When starting your generator, you should first check for a GFCI outlet. If the outlet is tripped, it means there’s a ground fault in the circuit. This is not an issue with all generators, but rather the transfer switch itself. If it’s not, you can change it to a three-pole transfer switch. This should resolve the problem.
Checking the fuel level
Before starting a Generac portable generator, make sure that the unit is completely unplugged from the power source. If the unit has a pull card, it may not rotate because of pressure built up in the carburetor. If it has an electric start, make sure that the battery is charged and connected. If it doesn’t have a pull card, it’s easy to clean it by using a needle.
When starting a Generac portable generator, it’s important to make sure that the fuel level is at a proper level. If you place it on an uneven surface, it could cause the generator to shut down. Then, adjust the fuel valve to the “On” position. If the fuel valve is too high or too low, you’re likely to damage the unit. Be sure to check the valve positions, as well.
