If you have two non-inverter generators, you can parallel them for maximum efficiency. Running two generators in parallel is convenient and easy to set up. This method of generating power also makes your generators lighter and more affordable. But before you can try paralleling two non-inverter generators, you must make sure that they have the same voltage and wattage.
Benefits of running two non-inverter generators in parallel
Running two non-inverter generators in tandem increases their reliability and redundancy. When one of the units fails, the other can continue to run to provide power to the RV. It also saves fuel, which makes them more cost-effective than big, bulky generators.
When running two non-inverter generators simultaneously, it is important to note that both must have identical power levels and phase angles. However, there are many ways to achieve this. For instance, load sharing can be done through the use of a droop system. In this method, the output of each generator is divided by its percentage, which reduces fuel consumption for both units. In addition, load sharing can be achieved by setting the two generators to run in varying amounts.
Paralleling two non-inverter generators can give you twice the power of one single unit. However, it must be done with care to ensure safety and to prevent any damage to the original generator. Moreover, paralleling two non-inverter generators is more cost-effective and easier to set up than running two series generators.
Easy to set up
There are several advantages to paralleling two non-inverter generators. First, you will have more power than if you only have one generator. You can also use the additional power to run the air conditioning in your RV. Second, it is safe and easy to set up. However, it is important to follow the manufacturer’s instructions. You will need to use the correct cables and make sure the two generators are compatible with each other. You also don’t want to do any homemade hacks when you are setting up a parallel set up.
Third, you can save money. The main advantage of paralleling two non-inverter generators is that it’s easier and cheaper to set up. In addition, this setup is more stable because the machines will be operating at different frequencies. However, it’s important to be aware that the two paralleling machines must be the same wattage. Otherwise, you could damage the electronics that connect to the generators.
Cheaper
If you need a backup generator, a cheap parallel non inverter generator may be the best choice. These generators are usually more fuel efficient. The main motor runs at constant speed, so they can take more load at higher fuel supply, and release it at lower fuel supply. This type of generator is often used for a camper van’s AC. It is also easier to install, and is usually cheaper. However, you should be aware of certain problems when paralleling a generator.
The first thing to remember when paralleling two non inverter generators is that you need to use the same frequency. If you have two non inverter generators that have different frequencies, you may end up damaging the electronics connected to them. Another important thing is to make sure that you have a compatible interface. Then, you can connect the two parallel generators to each other, distributing the load between them.
Another problem with paralleling non inverter generators is that they are not designed for paralleling. This can be dangerous if done improperly, and you can end up with a system that produces less power than you expected. A better option is to get two inverter generators that have the same output wattage. This way, you can avoid the risk of overloading the smaller unit.
